Avaya 555-233-116 - Manual (Page 106)

External modems
555-233-116 106 Issue 4 October 2002
Configuring the DTE dialer
Now define the command interface that the modem should use when dialing. The
RS-232 interface uses control characters to pass communications commands
and control the transmission. These are user-configurable. We need to disable
the result-code options while retaining the default values for the other control
characters. Proceed as follows.
Opening the DTE Dialer menus
1. From the Edit StrapGroup > prompt, press the right-arrow button once.
The DTE Dialer menu heading appears.
2. Press F1 to select DTE_Dialer.
The DTE Dialer Type (AT) menu heading appears.
Skipping to the result-code options
To reach the options we need to set, we have to skip over a number of other
options without making changes. Proceed as follows.
1. From the DTE Dialer Type (AT) menu heading, press F1 to select Nxt.
The AT Escape Char menu heading appears.
2. Press F1 to select Nxt.
The Escape GuardTim menu heading appears.
3. Press F1 to select Nxt.
The BreakForceEscap menu heading appears.
4. Press F1 to select Nxt.
The CommandCharEcho menu heading appears.
5. Press F1 to select Nxt.
The CarriageRtn Char menu heading appears.
6. Press F1 to select Nxt.
The Backspace Char menu heading appears.
7. Press F1 to select Nxt.
The Linefeed Char menu heading appears.
8. Press F1 to select Nxt.
The ResultCodes (Enable) menu heading appears.