Avaya 555-233-116 - Manual (Page 131)

Administering IP node names
Issue 4 October 2002 131 555-233-116
After you have successfully administered and validated the connection between
the adjunct and the C-LAN circuit pack through the IOLAN+, you can disconnect
the laptop or other PC from the IOLAN+. No further IOLAN+ administration is
required.
Potential failure scenarios and repair actions
If a link goes down between the terminal server and the switch, you must reboot
the terminal server for the link come back up. If you are performing a software
upgrade or if a system reset occurs, you must reboot the terminal server to restore
the link. See
‘‘Rebooting the IOLAN+’’ on page 127 for instructions.
Administering IP node names
You must administer the IP addresses of the C-LAN board, any adjunct that
connects directly to the LAN, the terminal server (if appropriate), and the PC
running the Reliable Session-Layer Protocol (if appropriate). You use the Node
Names screen to do this.
1. Type change node-names ip and press RETURN .
2. Enter the name and the IP address of the C-LAN board, as well as any
adjunct, terminal server or PC you need to administer.
** Administrator ** SERVER STATISTICS Terminal: 2
1. port1 Talking to host 172.22.22.67.5111<DSR+CTS+DCD >DTR+RTS
2. port 2 SERVER STATISTICS <DSR+DCD >DTR+RTS
3. port 3 waiting for DSR or DCD >DTR+RTS
4. port 4 modem waiting for DSR or DCD >DTR+RTS
REM <unknown> logged out
LOG logger not enabled
________________________________________________________________________________
Press <RETURN> to see list of options.
IOLAN PLUS v4.02.00 a CDi iolan-st