Avaya 555-233-116 - Manual (Page 65)

Connect data modules
Issue 4 October 2002 65 555-233-116
4. The CONTINUE? prompt appears. Press the ENTER/YES button.
Setting the break-disconnect option on 7400A DCE
This setting specifies the length of the BREAK signal, a string of 10 or more
spaces that tells the host that the user needs to interrupt operations. There are
three options: TRIPLE, LONG (the default), and NONE. Accept the default values,
unless otherwise instructed.
1. When the SET BREAK DISC? prompt appears, press the NEXT/NO
button to keep the default.
Configuring the RS-232 interface on 7400A DCE
You can set each pin of the RS-232 cable to meet the needs of specific
applications or connected equipment. however, in most cases, you can use the
defaults.
To set the EIA leads, proceed as follows:
1. When the SET LeadName LEAD? prompt appears, press the NEXT/NO
button to keep the default or the ENTER/YES button to make a change.
CONTINUE?
DATA NEXT/NO BACK ENTER/YES
● ❍ ❍ ➜ ●
Push the button indicated by the arrow ( ➜ )
SET BREAK DISC?
DATA NEXT/NO BACK ENTER/YES
● ➜ ● ❍ ❍
Push the button indicated by the arrow ( ➜ )
SET LeadName LEAD?
DATA NEXT/NO BACK ENTER/YES
● ➜ ● ❍ ❍
Push the button indicated by the arrow ( ➜ )