BNC 1201 - 6 1/2 Digit Digital Multimeter - Manual (Page 98)

99
※ Note: The output 2 is only for 4-wired resistance measurement.
Please refer to the above picture for more connection information. When
you use 4-wired resistance measurement with scanner card, please note
that the channel 1 is relative to the channel 6, channel 2 to channel 7 and
so on.
※ Note: Setting range of scanner card is only limited on DCV, DCI, ACV,
ACI and Resistance functions. As to the current measurements, users
can install current shunts on the circuit board R1 and R2 to allow indirect
AC and DC current measurements to be made through channels 1 and 6
only.
Remark 1: In the default situation, current shunts are not installed in
the scanner card.
Remark 2: When the current shunts are installed the channel 1 and
channel 6 will be limited to the current measurement unless users
release the shunts of the R1 and R2 .)
※ Note: The Information regarding the Limitation of Input Signals in
Scanner Card is in the following statement.
10 Channels: 10 channels of 2-pole relay input. All channels configurable to
4-pole.
CAPABILITIES: Multiplex one of ten 2-pole or one of five 4-pole signals into
DMM.
INPUTS
Maximum Signal Level: