ACU-RITE 300S READOUTS - Manual (Page 32)

18 I
I - 2 Gener
a
l Oper
ations f
o
r 30
0S
When two DRO views are configured, the DRO mode includes a VIEW
soft key which is used to toggle between DRO 1 and DRO 2 views.
The current view (1 or 2) is indicated on the soft key.
To setup the DRO views, press SETUP, cursor to DRO view settings,
and press ENTER. The configuration form will open.
Press the axis key to turn that axis display on. If an axis key is pressed
on an axis that is already on, it will turn off. The default configuration
is that all available axes are on for DRO 1, and all axes are off for
DRO 2. The 300S requires that at least one axis must be turned on at
all times. Axis view settings are remembered when power is cycled.
Multiple DRO views are only available when the full screen DRO is
displayed. In screens where the small DRO is displayed, all axes
positions are displayed and multiple DRO views are not available.
When running a program or a single cycle pattern, the large DRO uses
the current DRO view that is selected. The view with the graphic and
small DRO will show all available axes.
The size of the position values, and the axis labels are
adjusted based on the number of axes being displayed.
Smallest at 4 axes, largest at 1, or 2 axis display.
Axis keys correspond to the axes being displayed in the
current DRO view. If only two axes are being displayed,
and there are more axis keys (3 or 4), then only the top two
keys will function. Unmatched keys are ignored.