ACU-RITE 300S READOUTS - Manual (Page 53)

300S 39
I - 3 Milling Specific Oper
ations
Circle, and Linear Pattern Table Entry
The Circle, or Linear Pattern Table is used to define up to 10 different
circle hole patterns (Full, or Segment), and 10 different linear hole
patterns (Array, or Frame).
8 Access the Pattern Table from the DRO soft key menu by pressing
the FEATURES soft key.
8 Press the CIRCLE PATTERN, or LINEAR PATTERN soft key.
„ The Pattern Table will show all of the patterns that have been
previously defined.
8 Press the UP/DOWN arrow keys to define a new pattern, or edit an
existing pattern.
8 Highlight the table entry, press the NEW, or EDIT soft key (or
press ENTER).
„ A Circle, or Linear Pattern form is opened.
8 Enter the information to define the pattern, then press ENTER.
„ The pattern will be entered into the appropriate table. It can now
be modified, executed, or referred to from a program.
8 To delete a pattern from the table press the CLEAR soft key. Press
YES to confirm deletion from the table.
The pattern table, and its entries are saved to memory.
They will stay in memory until deleted, or changed, and are
not affected by a power cycle.