ACU-RITE 300S READOUTS - Manual (Page 44)

30 I
I - 3 Milling Specific Oper
ations
8 Press the DATUM soft key.
8 Press the DOWN arrow key to select the item you need.
8 Press the PROBE soft key.
Probe the 1st edge X
8 Move the edge finder toward workpiece edge 1 until the LEDs in the
edge finder light up.
Probe the 2nd edge in X
8 Move the edge finder toward workpiece edge 2 until the LEDs in the
edge finder light up. The distance between the edges is displayed
on the message box.
8 Retract the edge finder from the workpiece.
Enter the value for X
8 Enter coordinate (X = 0.0), and transfer coordinate as datum for the
centerline.
8 Press the ENTER hard key.
Example: Probe the center of a hole with an edge finder, and set
the datum 2.00 from the circle’s center
X coordinate of the circle center: X = 2.00”
Y coordinate of the circle center: Y = 0.00”
8 Press the DATUM soft key.
8 Press the DOWN arrow key to select the item you need.
8 Press the PROBE soft key.
8 Press the CIRCLE CENTER soft key.
8 Move the edge finder toward the first point 1 on the circumference
until the LEDs in the edge finder light up.
8 Probe two additional points on the circumference in the same
manner. Further instructions appear on the screen. See Instruction
Box for the measured diameter.
Enter center point X X = 2.00”
8 Enter the first coordinate (X = 2.00”).
8 Press the DOWN arrow hard key.
Enter center point Y Y = 0.00”
8 Accept default entry Y = 0.00”.
8 Press the ENTER hard key.