ACU-RITE 300S READOUTS - Manual (Page 98)

84 II
II - 1 Installation Set
u
p Starting a Non-Linear Error Compensation Table
8 Select Non-linear by pressing the TYPE soft key.
8 To start a new error compensation table, first press the EDIT TABLE
soft key.
8 All correction points (up to 200) are equally spaced from the start
point. Enter the distance between each of the correction points.
Press the DOWN arrow key.
8 Enter the table’s start point. The start point is measured from the
scale’s reference point. If this distance is not known, you can move
to the location of the start point, and press TEACH POSITION.
Press ENTER.
Pressing ENTER will save the spacing, and start
point information.