ACU-RITE 300S READOUTS - Manual (Page 57)

300S 43
I - 3 Milling Specific Oper
ations
The Circle Pattern table now shows the pattern that was just defined
as pattern 1.
2nd step: Execute circle pattern
8 Press the RUN soft key.
„ The distance-to-go view is displayed.
8 Move to the hole, move the X, and Y axis until their display values
show 0.0.
8 Drill (Z depth): If a depth was entered into the pattern, move Z until
it’s display value shows 0.0. Otherwise, drill to the desired depth.
8 Press the NEXT HOLE soft key.
8 Continue to drill the remaining holes in the same manner.
When the pattern is complete, press the END soft key.