ACU-RITE 300S READOUTS - Manual (Page 76)

62 I
I - 4 T
u
rn
ing Specific Oper
ations
Start Point
8 X: Enter the coordinates for the start point as previously defined
(0.0).
„ Typically 0.0 is the normal starting position.
8 Press the DOWN arrow key.
8 Zo: Enter the coordinates for the start point as previously defined
(0.0).
„ Typically 0.0 is the normal starting position.
8 Press the DOWN arrow key.
End Point
8 X: Enter the final cut thread Diameter.
„ This is the small OD for external threads, and the large ID for
internal threads.
8 Press the DOWN arrow key.
8 Zo: Enter the end point of the thread (thread length).
8 Press the DOWN arrow key.