ACU-RITE 300S READOUTS - Manual (Page 56)

42 I
I - 3 Milling Specific Oper
ations
Example: Enter data and execute a circle pattern.
1st step: Enter data
8 Press FEATURES soft key.
8 Press CIRCLE PATTERN soft key.
8 Press UP/DOWN hard keys to select pattern 1.
8 Press ENTER hard key.
8 Press FULL/SEGMENT soft key until FULL is selected.
8 Press DOWN ARROW hard key to move to the next field.
8 Enter 4 for the number of holes.
8 Enter X= 2.0”, Y= 1.5” for the circle pattern center location.
8 Enter 5” for the radius of the circle pattern.
8 Enter 25° for the start angle.
8 The end angle is 295°, and can not be changed because the pattern
is full.
8 Enter depth of -.25”.
„ The depth of the hole is optional, and may be left blank.
8 Press ENTER