ACU-RITE 300S READOUTS - Manual (Page 41)

300S 27
I - 3 Milling Specific Oper
ations
TOOL UNIT
8 Enter the tool unit (inch/mm).
8 Cursor to the Tool Type field.
TOOL TYPE
8 Press TOOL TYPES soft key.
8 Press ENTER.
Only the tools set using the same reference surface may be
changed without having to reset the datum.
If the tool table already contains tools in which the length
has been set, the reference surface should first be
established using one of them. If not, you will not be able
to switch between the new tools and the existing tools
without having to re-establish the datum. Before adding the
new tools, select one of the tools from the tool table. Touch
the tool to a reference surface and set the datum to 0