Unpacking the drive components – ElmoMC SimplIQ Digital Servo Drives-Solo Trombone Installation Guide User Manual
Page 17
Solo Trombone Installation Guide
Installation
MAN-SOLTROIG (Ver. 1.203)
17
3.2. Unpacking the Drive Components
Before you begin working with the Solo Trombone, verify that you have all of its components,
as follows:
•
The Solo Trombone servo drive
•
The Composer software and software manual
The Solo Trombone is shipped in a cardboard box with styrofoam protection.
To unpack the Solo Trombone
1.
Carefully remove the servo drive from the box and the Styrofoam.
2.
Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3.
To ensure that the Solo Trombone you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Solo Trombone.
It looks like this:
The part number at the top gives the type designation as follows:
4.
Verify that the Solo Trombone type is the one that you ordered, and ensure that the
voltage meets your specific requirements.