ElmoMC SimplIQ Digital Servo Drives-Solo Trombone Installation Guide - Manual (Page 81)

Solo Trombone Installation Guide Technical Specifications
MAN-SOLTROIG (Ver. 1.203)
www.elmomc.com
81
4.7.3. Analog Input
Feature Details
Maximum operating differential voltage ± 10 V
Maximum absolute differential input voltage ± 16 V
Differential input resistance 3.74 kΩ
Analog input command resolution 14-bit
4.8. Communications
Specification Details
RS-232 Signals:
• RxD , TxD , Gnd
• Full duplex, serial communication for setup and control.
• Baud Rate of 9,600 to 57,600 bit/sec.
CAN CAN bus Signals:
• CAN_H, CAN_L, CAN_GND
• Maximum Baud Rate of 1 Mbit/sec.
Version:
• DS 301 V4.01
Layer Setting Service and Protocol Support:
• DS 305
Device Profile (drive and motion control):
• DS 402
4.9. Pulse-Width Modulation (PWM)
Feature Details
PWM resolution 12-bit
PWM switching frequency on the load 2/Ts (factory default 22 kHz on the motor)
4.10. Brake
The brake can be controlled by Digital Output 1, which should be set to Brake.
Feature Details
Rated voltage 24 V +10%
Rated current 0.5 A
Input power 12 W