ElmoMC SimplIQ Digital Servo Drives-Solo Trombone Installation Guide - Manual (Page 38)

Solo Trombone Installation Guide Installation
MAN-SOLTROIG (Ver. 1.203)
www.elmomc.com
38
3.5. Auxiliary Feedback (Bi-Directional)
When using one of the Auxiliary Feedback options, the relevant functionality of the Auxiliary
Feedback's ports are software selected for that option. Refer to the SimplIQ Command
Reference Manual for detailed information about Auxiliary Feedback setup.
The Auxiliary Feedback connector has two ports: B1 and B2.
• Port B1 has three pairs of differential buffered inputs.
• Port B2 has three pairs of differential buffered outputs.
There are two modes of operation for this interface:
• Mode 1 (Composer Command: YA[4]=4) – see Section 3.5.2
When the Auxiliary port of the Solo Trombone is set by the software to act as an emulated
encoder output.
This is practical only when using the following Main Feedbacks:
Resolver
Interpolated Analog Encoder
Potentiometer and Tachometer
Absolute Encoder (Stegmann, Heidenhain or Panasonic)
 B1 input becomes inactive.
 B2 presents emulated differential buffered encoder output signals of the
Main Feedback.
• Mode 2 (Composer Command: YA[4]=2 or YA[4]=0) – Refer to Sections 3.5.3, and 3.5.4.
When the Auxiliary port of the Solo Trombone is set by software to act as an input
 B1 becomes an active differential buffered input.
 B2 presents differential buffered encoder output signals of B1.