ElmoMC SimplIQ Digital Servo Drives-Solo Trombone Installation Guide - Manual (Page 8)

Solo Trombone Installation Guide
MAN-SOLTROIG (Ver. 1.203)
www.elmomc.com
8
Chapter 1: Safety Information
In order to operate the Solo Trombone servo drive safely, it is imperative that you implement
the safety procedures included in this installation guide. This information is provided to protect
you and to keep your work area safe when operating the Solo Trombone and accompanying
equipment.
Please read this chapter carefully, before you begin the installation process.
Before you start, make sure that all system components are connected to earth ground.
Electrical safety is provided through a low-resistance earth connection.
Only qualified personnel may install, adjust, maintain and repair the servo drive. A qualified
person has the knowledge and authorization to perform tasks such as transporting, assembling,
installing, commissioning and operating motors.
The Solo Trombone servo drive contains electrostatic-sensitive components that can be
damaged if handled incorrectly. To prevent any electrostatic damage, avoid contact with highly
insulating materials, such as plastic film and synthetic fabrics. Place the product on a
conductive surface and ground yourself in order to discharge any possible static electricity
build-up.
To avoid any potential hazards that may cause severe personal injury or damage to the product
during operation, keep all covers and cabinet doors shut.
The following safety symbols are used in this manual:
Warning:
This information is needed to avoid a safety hazard, which might cause bodily
injury.
Caution:
This information is necessary for preventing damage to the product or to other
equipment.