Sensaphone SCADA 3000 Users manual - Manual (Page 14)

xii
SCADA 3000 User’s Manual
modem and Voice Boards .............................................................................................3-4
Modem Card Installation ......................................................................................3-4
Installation of the Modem Card ............................................................................3-5
Voice Board Installation ...............................................................................................3-6
Installation ............................................................................................................3-7
Chapter 4: POWeR SUPPLY & BATTeRY BACKUP .................................... 4-1
Power ReqUIRemeNTS ................................................................................................4-1
GROUNDING AND POWER SURGE PROTECTION............................................4-2
Power Supply Fuse ...............................................................................................4-2
Estimating Power Consumption ............................................................................4-2
Power Supply Selection ........................................................................................4-3
BACKUP BATTeRY (optional) ........................................................................................4-3
Powering the SCADA 3000 with Solar Cells ................................................................4-4
Chapter 5: INPUT WIRING & CONFIGURATION .................................... 5-1
General Wiring Considerations .............................................................................5-1
Terminal Blocks.............................................................................................................5-1
Input Configuration ......................................................................................................5-2
Correct Jumper Positioning ...................................................................................5-2
Normally Open/Normally Closed Dry Contacts ....................................................5-2
1OK Thermistors ...................................................................................................5-3
Analog Voltage Output Transducers (0–5VDC) ......................................................5-4
4–20mA Current Loop Transducers .......................................................................5-5
Chapter 6: OUTPUT WIRING ................................................................... 6-1
Notes on Correct Use ...................................................................................................6-1
Chapter 7: I/O eXPANSION mODULeS .................................................... 7-1
Adding expansion modules ...........................................................................................7-1
Cabling Notes .......................................................................................................7-1
modules ........................................................................................................................7-1
Power Supply .......................................................................................................7-2
Communications Bus Wiring ................................................................................7-2
Bus Termination ..................................................................................................7-3
module Types ................................................................................................................7-4
Input Modules ......................................................................................................7-4
Output Modules ...................................................................................................7-4
Chapter 8: SOFTWARe INSTALLATION & SeTUP ..................................... 8-1
minimum Requirements ...............................................................................................8-1
Installing the Software ..................................................................................................8-1