Sensaphone SCADA 3000 Users manual - Manual (Page 231)

21-7
Chapter 21: PC Alarm Dialout
“SCADA 3000 Alarm exists”
“Enter Alarm ID” (waits for 4-digit entry)
“(Custom ID message)”
“Alarm channel 1, (Custom alarm message), is too high, when the alarm occurred, it
was 82.90 degrees Fahrenheit.”
“Enter acknowledgement code” (555 acknowledgement code entered)
“Alarm ID 0001 acknowledged, goodbye”
Numeric Pager
When dialing out to a destination programmed as “Pager,” the PC Alarm Dialout program
leaves the unit ID number (usually the computer's phone number), and the alarm ID number,
on the display of a numeric pager. A sample is shown below:
To acknowledge the alarm you must call the computer back and enter the alarm ID number
and the acknowledgement code. (See voice sample above.)
Alphanumeric Pager
When dialing out to a destination programmed as “Alpha,” the PC Alarm Dialout program
leaves a text message up to 80 characters long on the display of an alphanumeric pager. A sam-
ple is shown below:
To acknowledge the alarm you must call the computer back and enter the alarm ID number
and the acknowledgement code. (See voice sample above.)
FAX and e-mail
When sending messages via FAX or e-mail, the PC Alarm Dialout program sends a text mes-
sage. A sample follows.
To acknowledge the alarm you must call the computer back and enter the alarm ID number
and the acknowledgement code. (See voice sample above.)