Sensaphone SCADA 3000 Users manual - Manual (Page 50)

5-4
SCADA 3000 User’s Manual
Figure 5: Wiring a Thermistor
Analog Voltage Output Transducers (0–5VDC)
The SCADA 3000 is compatible with transducers that produce an analog output of 0 to 5VDC.
Analog voltage output devices can be connected directly to the input terminals but be sure to
follow the polarity markings on the unit. Choose an input and connect the wires to the corre-
sponding screw terminals for that input. The configuration jumper should be set to the storage
position as indicated in the diagram below:
Figure 6: Wiring a 0-5V transducer
The shunt set to the 0–5V position is reflected in the following circuit diagram.