Sensaphone SCADA 3000 Users manual - Manual (Page 83)

11-1
Chapter 11: Programming for Phone Line Applications
Chapter 11: PROGRAmmING FOR
PHONe
LINe APPLICATIONS
DeSTINATIONS
SCADA 3000 will call up to 64 telephone numbers or E-mail addresses (both referred to as
destinations) to report alarm conditions or send reports. Destinations can be voice calls, fax
machines, computers with modems running SCADA 3000 software, E-mail addresses, numeric
pagers, or alphanumeric pagers. Choose Program from the main menu, then select Destinations.
You can also access the Destination programming from the Toolbar button labeled Destinations.
Figure 1: Dialout Destinations form
The Dialout Destinations form allows you to program information for up to 64 destinations.
The parameters and their options follow:
Name
This field allows you to program a description (16 characters max) for each destination. These
descriptions are used to reference the destinations in other parts of the programming. The
name will also appear on faxes and E-mail transmissions whenever an alarm or report is sent to
the destination. If you are entering a fax destination be sure to use the name of the person who
you intend to receive the fax.
Destination
The actual telephone number or E-mail address SCADA 3000 dials to deliver its report or
alarm message. The Destination field can be up to 64 characters long for E-mail addresses and
64 digits for all other Dial Types and may consist of numbers, letters, and special dialing codes.
Numeric Pagers
The SCADA 3000 can send alarm messages to numeric pagers. It will automatically send its
telephone number and the alarm number when dialing to a numeric pager. All you have to do
is enter the telephone number of your pager.
Example: (301)565-2300
Note : If your pager service is answered by a voice-prompted message, or if your
pager service allows only a few seconds to enter a number before disconnecting,
you will need to enter additional programming. See the Special Dialing codes
section below.
Alphanumeric Pagers
The SCADA 3000 can dial alphanumeric pagers to send alarm messages. The SCADA 3000
will send the unit description, telephone number, input name and the real-time input value.