Sensaphone SCADA 3000 Users manual - Manual (Page 147)

14-23
Chapter 14: Real-Time Screen Design
Height: Vertical size in pixels (overridden if you chose a Max/Min Height).
Hint: Type in the text that will appear upon mouseover.
Left: Sets the position of the component as measured from the left side of the pal-
ette.
Max Value: Upper datapoint value limit
Min Value: Lower datapoint value limit
Show Hint: Checkbox. Enables the hint message to display on mouseover.
Stay On Top: Checkbox. Check if you want the container component to float
above any other graphics.
Top: Y coordinate of the top edge of the container.
Value: Realtime datapoint value.
Visible: Checkbox. Check to make component visible.
Width: Horizontal size in pixels (overridden by Max/Min Width values, if any.)
PLACING VALVe COmPONeNTS ON THe PALeTTe
There are four valve components on the tab: Valve Actuator, Valve, Valve Butterfly, and Valve
Meter.
Figure 23: Valve Tab
Properties
Actuator Type (Actuator only):
atAirMotor
atElecMotor
atHydraulic
atSolenoid
Align: To align graphic/component to edges of the palette area.
alBottom: Stretches the component across the bottom of the palette.
alClient: Fills the palette with the component. Useful for adding a background
graphic.
alLeft: Stretches the component along the left edge of the palette.
alNone: No realignment is applied. Note: this will not correct any other
previously applied alignment.
alRight: Stretches the component along the right edge of the palette.
alTop: Stretches the component across the top of the palette.