Rockwell Automation 160 SSC Series C FRN 7.xx - Manual (Page 11)

Getting Started 1-5
Optional Drive Features
The drive features identified in the figure below are optional. See Appendix B for
catalog numbers. (Finger guards omitted for clarity.)
Optional Drive Features Figure 1.4
• Dynamic Brake Module option allows you to connect dynamic brake
resistors. Not available on .37 or .55 kW (.5 or .75 HP) ratings.
Important: P52 - [DB Enable] must be enabled for proper operation.
• Line Filter Module option is available to reduce conductive emissions.
• Program Keypad Module option can be ordered separately and field installed,
or as a factory installed option by adding “P1” to the end of the catalog number.
Refer to Chapter 3, Program Keypad Module for a detailed explanation of
functionality.
• DeviceNet Communication Module option allows control and monitoring of
parameters via a DeviceNet network.
• RS-232 Communication Module option allows control and monitoring of
parameters via a RS-232 network.
• Remote Programming Adapter option allows connection to Remote Keypad
Module or Copycat Keypad Module via cable (1 to 3 meters).
• 24V DC Interface Module option allows you to command the drive with 24V
logic (sinking inputs).
• Capacitor Module option allows you to connect an external capacitor module.
Provides extended ride through capability and improved inherent braking
performance.
Dynamic Brake
Module
Line Filter Module
Program Keypad Module
or
DeviceNet Communication Module
or
RS-232 Communication Module
or
Remote Programming Adapter to:
Remote Keypad Module
or
CopyCat Keypad Module
24V DC Interface Module
Capacitor
Module
DC+ W/T3
1 3 4 5 6 7 8 9 10 11 2
V/T2 U/T1 DC–
BR+ T/L3 S/L2 R/L1 BR–