Rockwell Automation 1440-TPS02-01RB XM-320 Position Module - Manual (Page 74)

Publication GMSI10-UM005C-EN-P - May 2010
66 Configuration Parameters
Data Parameters The Data parameters are used to view the measured values of the input
channels and the 4–20mA outputs, as well as to monitor the status of the
channels, alarms, and relays.
Channel Data
TIP
To view all the data parameters in the XM Serial
Configuration Utility, click the View Data tab.
Channel Data Parameters
Parameter Name Description Values/Comments
Channel Status States whether a fault condition exists. If a fault
exists, the measurement value may not be accurate.
Measurement Value Shows the current measurement value for the
channel.
States whether a transducer fault exists. Possible status values: No Fault
Fault
Transducer DC Bias Shows the measured average DC offset of the
transducer signal. This value is compared with Fault
High and Fault Low to determine whether the
transducer is working properly.
4-20mA Output A and B (XM
Serial Configuration Utility only) Shows the current output value in the range of 4.0 to
20.0mA.
XM Configuration
Utility EDS File
Transducer Fault Transducer
Status