Metrohm 719 S Titrino - Manual (Page 48)

2.11. Data output
719 S Titrino
44
2.11 Data output
Reports for the output at the end of a determination
With <DEF>, the report sequence at the end of the
determination is defined.
The entries are specific to the method and are stored in
the method memory.
report:
Definition of report blocks to be printed automatically at
the end of the determination.
The display texts of the Titrino are shown to the left.
The values are the default values.
>report
report:
report:full
Report sequence: full, short, param, calc, calib, ff
Select a block with <SELECT>. If you require more
than one report block, set a ";" as a delimiter between
the blocks.
Meaning of the report blocks:
full Full result report with raw results, calculations and statistics.
short Short result report with calculations and statistics.
param Parameter report.
calc Report with formulas and operands.
calib Calibration data.
ff Form feed on printer.
Original reports which are put out automatically at the end of the titration can be printed
with recalculated values at any time. Key sequence:
<PRINT><REPORTS><ENTER>.
Original reports have double dashes ==== at the end, whereas recalculations are
marked by single dashes
----
.
Report outputs can be stopped with <QUIT>.
DEF
(
2
def
>report