Metrohm 789 Robotic Sample Processor XL - Manual (Page 34)

2.2 Instrument setup
26 Metrohm Sample Processor, Installation
2.2 Instrument setup
2.2.1 Setup
Packaging
A Metrohm Sample Processor and its specially packed accessories are
supplied in very protective special packaging consisting of shock-
absorbing plastic foam. Please store this packaging in a safe place; it is
the only way in which the safe transport of the instrument can be guar-
anteed.
Checks
Please check that the delivery is complete and undamaged immedi-
ately on receipt (compare with delivery note and list of accessories
given in Section 6.3, p. 137). If transport damage is evident please re-
fer to the information given in Section 6.4.1 "Warranty", p. 162.
Location
The Sample Processor is a robust instrument and can therefore be
used even in rough surroundings in laboratories and factories.
However, please ensure that it is not exposed to a corrosive atmos-
phere. The instrument should be serviced at regular intervals, particu-
larly when operated under rough conditions.
2.2.2 Mains connection
This instrument must only be operated at the specified mains voltages
(see rear panel of instrument).
Protect the connection sockets against moisture.
S: 115 VA U: 100 - 240 V f: 50 - 60 Hz
Mains connection 25