Banner PresencePLUS P4 COLOR Series - Manual (Page 339)

Enter the number of seconds failed images should be displayed on the optional
NTSC video monitor. The default is 1 second. Failed Image Hold
Enter the number of milliseconds to delay the camera before it takes a picture after
the sensor receives a valid trigger. The default is 0 milliseconds. Trigger Delay Adjust
Note: Using the Trigger Delay when a part is triggered too early may be easier than moving the sensor.
Select Tab
10.11 Log Tab
Fields in the Runs screen's Log tab are described below.
Mode
• Pass-Logs only passed inspections based on Strategy.
• Fail-Logs only failed inspections based on Strategy.
• RT-Log remotely-taught inspections based on Strategy.
• RT Fail-Log failed, remotely-taught inspections based on Strategy.
339 Minneapolis, MN USA Banner Engineering Corp.
Run Screen 2/2010