Connecting an audio port (sold separately), Powering the system on, Connecting an audio port (sold separately) -3 – ClearOne NetStreams Quartet User Manual
Page 21: Powering the system on -3
Getting Started
3-3
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
Connecting an Audio Port (sold separately)
To connect an Audio Port AP500, run a CAT5 (terminated 568a) from the Audio Port
to the connector on the back of the keypad labeled EIM.
EIM runs should be less
than 60 feet.
Powering the System ON
1.
Press the Power switch on the rear of the MRP to the ON position (-).
2.
To start the system and get to the home screen, press the ON button on the Quartet
remote and the following screen appears.
Figure 3-3
Home screen
The home screen shows you the FM channel selected and lists the rooms across the
top. Just below the room names are the sources that are playing within each room