Adjusting the paging chime bell setting, Adjusting the paging chime bell setting -20 – ClearOne NetStreams Quartet User Manual
Page 41
Quartet User’s Guide
4-20
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 4-23
Locking or unlocking the keypad
4.
Press the up or down arrow key to lock and unlock the keypad.
5.
When you are done locking or unlocking the keypad, press the MENU key again.
From the KEY LOCK menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
SP-ZONE - to lock or unlock the keypad for a super zone.
SET ALL - sets all the rooms to this setting.
To unlock a locked keypad, enter the unlock code defined in the SYSTEM menu
(factory default: 0000). To relock an unlocked keypad at the keypad, press the shift key
( + *) followed by the key.
Adjusting the Paging Chime Bell Setting
The CHIME BELL setting changes the sound used to indicate that the room is being
paged or that an intercom session has started when a user starts to page to all rooms.
To adjust the sound, follow these steps:
1.
Use the down arrow key to highlight CHIME BELL.
2.
Press the MENU key to select CHIME BELL.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears:
Figure 4-24
Setting the sound when you page all rooms
4.
Use the up or down arrow to select between 1 and 4.