Setting up a super zone, Setting up a super zone -12 – ClearOne NetStreams Quartet User Manual
Page 33
Quartet User’s Guide
4-12
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
From the E-N ADJ menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
FACTORY - returns this setting back to the factory setting.
SET ALL - sets all the rooms to this setting.
Setting Up a Super Zone
The SP ZONE setting is used to group rooms into a super zone. Rooms in a super zone
act as one.
There can be only one super zone per system. To group rooms in a super zone, follow
these steps:
1.
Select the ROOM menu.
2.
Select a room.
3.
Use the down arrow key to highlight SP ZONE.
4.
Press the MENU key to select SP ZONE.
5.
Use the down arrow key to highlight MODIFY and press the MENU key.
The currently selected
room is assumed to be
in the super zone. To
tell other rooms to
join the super zone,
change their setting to
INCLUDE. If all
rooms are set to
EXCLUDE, no super
zone is active.
The following screen appears:
Figure 4-15
Grouping rooms into a super zone
6.
Use the left and right arrow keys to either include a zone or exclude the zone.
7.
When you are done grouping rooms, press the MENU key.
From the SP ZONE menu, you can also select:
NEXT - to move to the previous menu item.
PREV - to move to the next menu item.
FACTORY - to return this setting back to the factory settings.
SET ALL - not active.