Changing the aux mode, Changing the aux mode -21 – ClearOne NetStreams Quartet User Manual
Page 42
Using the Setup Menus
4-21
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
5.
When you are done adjusting the sound, press MENU again.
From the CHIME BELL menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
FACTORY - returns this setting back to the factory setting.
SET ALL - sets all the rooms to this setting.
Changing the AUX MODE
The AUX MODE setting determines if the Audio Port output in the room is restricted
to that room or if other rooms can listen to the Audio Port as well. If the Audio Port is
being accessed from another room, the room with the Audio Port will not be able to be
paged or intercomed.
1.
Use the down arrow key to highlight AUX MODE.
2.
Press the MENU key to select AUX MODE.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears:
Figure 4-25
Changing the AUX MODE setting
4.
Use the up or down arrow to change the LOCAL setting to ALL ROOMS if you
want this Audio Port to be accessible from other rooms.
5.
When you have finished selecting AUX MODE, press the MENU key.
From the AUX MODE menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
FACTORY - returns this setting back to the factory setting.
SET ALL - sets all the rooms to this setting.