Audio port sensitivity adjustments (aux gain), Audio port sensitivity adjustments (aux gain) -11 – ClearOne NetStreams Quartet User Manual
Page 32
Using the Setup Menus
4-11
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
4.
Use the right or left arrow key to set the to set the speaker to 4 ohm, 6 ohm, or
8ohm.
5.
If you have an Audio Port connected and want to use an external amplifier
connected to the RCA outputs of that Audio Port, press the down arrow key to
select INT and use the right or left arrow key to change it to AUX. The INT + AUX
setting allows an external amplifier to be used and at the same time drives the
speakers using Quartet’s internal amplifier.
If the SPEAKER
setting is set to AUX
or INT + AUX, the
audio port’s input
cannot be global.
Other rooms cannot
listen to this room’s
audio port input when
Quartet is sending a
signal to the Audio
Port’s output.
6.
When you are done setting the speaker, press the MENU key.
From the SPEAKER menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
SP-ZONE - to set the speaker on a super zone you have set up.
SET ALL - sets all the rooms to this setting.
Audio Port Sensitivity Adjustments (AUX GAIN)
The AUX GAIN setting adjusts the input sensitivity from 6db to -6db of the Audio
Port when you have an external source selected.
To adjust the input sensitivity of the Audio Port, follow these steps:
1.
Use the down arrow key to highlight AUX GAIN.
2.
Press the MENU key to select AUX GAIN.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears:
Figure 4-14
Adjusting the sensitivity of the Audio Port
4.
Use the up or down arrow key to adjust the sensitivity of the Audio Port.
5.
When you are done adjusting the sensitivity, press the MENU key.