Monitoring a room, Monitoring a room -15 – ClearOne NetStreams Quartet User Manual
Page 36
Using the Setup Menus
4-15
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
If allowed by the
ENABLE setting,
privacy can be turned
on at the keypad using
the shift key, followed
by the SHUF key.
Regardless of the
PRIVACY setting, the
room cannot monitor,
be monitored, page, or
intercom if that
room’s audio port is
set to global and is
being listened by
another room.
From the PRIVACY menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to previous menu item.
FACTORY - to return this setting back to the factory default. The factory default
setting is ENABLED/ON.
SET ALL - sets all the rooms to this setting.
Monitoring a Room
The MONITOR setting allows the installer to activate a room’s ability to monitor
another room. If the room is enabled, then that room can monitor any other room (as
long as the room does not have Privacy enabled).
1.
Use the down arrow key to highlight MONITOR.
2.
Press the MENU key to select MONITOR.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears:
Figure 4-18
Monitoring a room
4.
Press the up or down arrow key to either disable or enable monitoring from this
room’s keypad
5.
When you are done setting up monitoring, press MENU again.
From the MONITOR menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.