Key macro, Key macro -5 – ClearOne NetStreams Quartet User Manual
Page 58
Learning IR
5-5
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 5-7
Setting the macro time
4.
In response to the KEY prompt, select the delay time between each IR command
sent in a macro by pressing the right or left arrow keys. You can select from 0 to 5
seconds.
5.
Press the down arrow key to select the delay time between each IR command sent
in an RnR macro. You can select from 0 to 5 seconds. Use the right or left arrow
key to select the time.
6.
When you are done setting the RnR macro time, press the MENU key.
From the MACRO TIME menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
FACTORY - to return to the factory default.
SET ALL - sets all the rooms to this setting.
Key Macro
The KEY MACRO setting allows you to create a 4-step macro from the control
buttons. For example, if you learned the IR for power on to the Mode button (button 1)
and you learned the play IR code to the play button, a key macro could be created that
simulates pushing the Mode button to play.
To set up to two macros, follow these steps:
1.
Use the down arrow key to highlight KEY MACRO.
2.
Press the MENU key to select KEY MACRO.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears: