Adjusting the default volume, Volume, Adjusting the default volume -9 – ClearOne NetStreams Quartet User Manual
Page 30: Volume -9
Using the Setup Menus
4-9
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
CAUTION!
Adjusting the Default Volume
The DEF VOL setting sets the default volume between 0 and 15 when the room is first
turned ON.
The keypad’s volume
will use the default
volume or the keypad’s
volume if the keypad
volume is lower than the
default or after the MRP
has been powered
OFF/ON.
To change the default volume, follow these steps:
1.
Use the down arrow key to highlight DEF VOL.
2.
Press the MENU key to select DEF VOL.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears:
Figure 4-11
Setting the default volume
4.
Use the up or down arrow key to set the default volume.
5.
When you are done setting the default volume, press the MENU key.
Setting the default
volume too high could
be startling to a user
who was not
expecting a loud
system.
From the DEF VOL menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
FACTORY - returns this setting back to the default setting.
SET ALL - sets all the rooms to this setting.
VOLUME
The VOLUME setting adjusts the volume of the sound in the selected room. You can
select from 0 to 15db.
1.
Use the down arrow key to highlight VOLUME.
2.
Press the MENU key to select VOLUME and the following screen appears.