ClearOne NetStreams Quartet User Manual
Page 38
Using the Setup Menus
4-17
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
playing before it turns OFF, and a length of time before the designated source comes
back ON.
For example, before going to bed a user could enable RNR, 10 minutes later the
currently playing source will turn itself OFF, the keypad will wait 7 hours then switch
to the DVD player, and initiate a macro.
1.
Use the down arrow key to highlight RNR.
2.
Press the MENU key to select RNR.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears:
Figure 4-20
Setting up RNR
4.
Use the right or left arrow key to turn RNR ON or OFF.
5.
Next, press the down arrow key to adjust the OFF-TIME setting. This specifies the
length of time the keypad plays audio before turning itself OFF. You can select
from 1 to 12 hours in 30 minute increments.
6.
Press the down arrow key to adjust the ON-TIME setting. This specifies the length
of time the keypad waits before turning itself back ON.
7.
Press the down arrow key again to adjust the SOURCE setting and select a source
that comes back ON.
8.
When you are done setting up RNR, press the MENU key.
From the RNR menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
SP-ZONE - to set up RNR for a super zone.
SET ALL - sets all the rooms to this setting.
RNR can also be turned ON or OFF at the keypad using the shift key ( + *) followed
by the NEXT key. The keypad will visually indicate that RNR mode is active by
lighting the up, right, down, and left arrows in sequence.