2’s repeat, Macro time, 2’s repeat -4 macro time -4 – ClearOne NetStreams Quartet User Manual
Page 57
Quartet User’s Guide
5-4
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
2’S Repeat
2’s Repeat is the delay time between the first IR command sent and all consecutive IR
commands sent from the 2nd function on each button (Button Hold). If the Disable
option is selected, then there are no repetitive IR commands sent.
This setting can be
useful if a source needs
“processing time”
between IR commands.
If IR commands are sent
too quickly, they can
queue and create
unexpected results.
To set the 2’s Repeat time, follow these steps:
1.
Use the down arrow key to highlight 2’S REPEAT.
2.
Press the MENU key to select 2’S REPEAT.
3.
Use the down arrow key to highlight MODIFY and the following screen appears:
Figure 5-6
Setting the 2’s REPEAT delay time.
4.
Use the right or left arrow key to toggle between DISABLE and ENABLE.
5.
To set the 2’s Repeat time, use the down arrow key to select the delay time. You
can choose from .5 seconds to 1 second.
6.
When you are done setting the 2’s Repeat time, select the MENU key again.
From the 2’S REPEAT menu, you can also select:
NEXT - to move to the next menu item.
PREV - to move to the previous menu item.
FACTORY - to return to the factory default.
SET ALL - sets all the rooms to this setting.
Macro Time
The MACRO TIME setting adjusts the delay time between each IR command sent in a
macro and in an RnR macro.
To set the macro time, follow these steps:
1.
Use the down arrow key to highlight MACRO TIME.
2.
Press the MENU key to select MACRO TIME.
3.
Use the down arrow key to highlight MODIFY and press the MENU key. The
following screen appears.