ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 103)

Parameter Settings 8-13
This menu is used for defining the measurement location and, therefore, serves as one
of the most important menus involved in setting parameters.
Due to the limited area for display, the entire menu cannot display on the screen. The
black bar to the right of the menu options indicates that additional options are
available on the menu.
Use up and down arrow keys to scroll through the menu.
Name of Measurement Location
ADS recommends managing and designating names based on the names used in the
associated documentation. A name may contain up to 21 characters. Entering a
name on the screen is similar to entering text on a cellular phone:
After selecting the Measurement Place Name submenu from the PAR menu, the
default setting, ADS, will display. Toggle between uppercase and lowercase letters
using the up and down arrow keys.
Pressing the Alt key will select or deselect a set of special characters (e.g., % or #).
Select a specific character using the left or right arrow keys, and confirm the selection
by pressing Enter.
Figure 8-19 Setting the name for the measurement location
Enter the desired name using the keypad; each key represents three letters and a
number (Refer to Chapter 7, Initial Startup and Communication). Cycle among the
four characters by repeatedly pressing a key. The cursor automatically will proceed
to the next character if the key has not been pressed for two seconds.
Following are descriptions of the function keys:
Move the cursor to the left or the right.
Move the cursor to the left side to delete the
character to the left of the cursor.
Move the cursor to the right to create a character
representing a space.
Toggle between uppercase and lowercase letters.
Shift to uppercase letters.
Shift to lowercase letters.
Confirm the name entered and exit the menu.