ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 123)

Parameter Settings 8-33
Use this option to define the function and measurement range of each analog output.
The user typically can select and set 4 analog outputs; however,
Model 10 transmitters have only 2 analog outputs.
Channel number
Select the analog output, from outputs 1-4, for which to set the following parameters.
Name
This parameter is not required. Set this parameter only when saving the analog
output to the memory card. This name will be saved only to the card.
Follow the same procedure described in PAR/Measurement Place/Name.
Function
Assign the following functions based on the analog output channel selected through
the Channel Number parameter. Select the desired output function from the list:
z
Disabled No analog output signal is available.
z Output flow Analog signal output represents calculated flow volume.
z
Output level Analog signal output represents the depth level reading.
z Velocity Analog signal output represents the mean (or average) flow
velocity based on the individual velocity readings.
z
Water temperature Analog signal output represents the water temperature
reading.
z
Air temperature Analog signal output represents the air temperature
measured by the LUS air-ultrasonic sensor (output is available only when the
LUS sensor is connected).
z
Analog input 1 Analog output signal represents the analog input 1output
value assigned by the user.
z Analog input 2 Analog output signal represents the analog input 2output
value assigned by the user.
z
Analog input 3 Analog output signal represents the analog input 3 output
value assigned by the user.
z
Analog input 4 Analog output signal represents the analog input 4output
value assigned by the user.
The following functions also are available when using more than one velocity sensor:
Function
z
Velocity v1 Analog signal output represents average velocity from sensor 1.