ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 150)

8-60 ADS FlowShark Pulse O&M Manual
This menu indicates the calculated values that must be sent to the analog converter as
mA signals. While a Model 10 transmitter allows the user to set and display 4 analog
outputs, only analog outputs 1 and 2 physically exist.
The actual current on the output clamps will not display. The only visible
signal is the signal the analog output converter receives for output
purposes.
The unit can neither detect nor indicate faulty external wiring through
this menu.
I/O Menu: Relay Outputs
The user can view conditions calculated by the transmitter and later routed to the
relay for output purposes from this menu. Displays OFF or ON.
Figure 8-98 Digital values
The actual output condition of the relay contacts on the output clamps
will not display. The only signal visible is the signal the relay receives
for output purposes.
The unit can neither detect nor indicate faulty external wiring from this
menu.
I/O Menu: Sensors
This menu and the associated submenus allow the user to view and assess the sensor
status and operational conditions. It provides information on the measurement
location quality, cable layout, echo signal quality, and many other parameters.
When using 2 or 3 flow velocity sensors, select the sensor by choosing the
corresponding channel number. The menu that displays depends on the sensor
configuration (depth measurement from bottom up, depth measurement from top
down based on range, pressure measurement, or external sensor measurement):