ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 83)

C H A P T E R 7
Initial Startup and Communication
After installing and connecting the FlowShark Pulse transmitter and sensors (refer to
Chapter 6, Installation) and providing power to the unit, the user can communicate
with the unit. The user interface on the FlowShark Pulse enables the user to easily set
up basic and advanced settings on a graphic dialog to ensure reliable device
operation. This interface includes a keypad on the transmitter and is also accessible
through an Internet browser.
Communication with the transmitter through a browser can occur on-site or from a
remote location. Direct communication requires only an Ethernet connection using a
cross-link cable between the user’s PC/laptop and the FlowShark Pulse. Remote
access occurs over a TCP/IP network (LAN) or through an external GSM/GPRS
gateway.
This chapter includes instructions on establishing communication with the FlowShark
Pulse through an Internet brower, reading the display, and operating the keypad.
Review this chapter carefully to become familiar with the display and keypad before
configuring the device.