ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 93)

Parameter Settings 8-3
Basics for Setting Parameters
The transmitter operates automatically using the existing settings until the user enters
and accepts new input parameters. Once the user finishes entering all the new
settings, the system will prompt the user whether to accept the new values.
Following confirmation, the user must enter the following code number.
2718 Type in 2718 if prompted.
Do not give this code number to an unauthorized person. In
addition, do not leave the code next to or write it down on the
equipment. This number prevents access by unauthorized users.
If the user enters the wrong code three times, the system will abort the parameter
mode and initiate operation based on the existing parameters. If the correct code is
entered, the system will accept the modified parameters and reset. The reset will take
approximately 20 to 30 seconds.
In addition to saving modified parameters or rejecting modifications (by clicking No
at the end of the parameter setting procedure), the user also can return to the previous
menu level using the Back function. This enables the user to modify settings that
may have been overlooked without saving the settings modified previously.
Figure 8-1 Screen displayed once parameters are set
If the user verifies each parameter without modifying any of the parameters, the
system will not prompt the user at the end.
Because the language, units, contrast, and display brightness parameters only affect
presentation, and not measurement or output, the user is not required to enter the code
after modifying these settings.
This instruction manual describes all the configuration and
programming options for the FlowShark Pulse. The transmitter
type will determine the inputs and outputs available. While the
inputs/outputs may be programmable, they may not be available for