Rice Lake CLS-420 Cargo Lift Scale Installation Manual - Manual (Page 17)

CLS-420 Installation Manual 12
3.0 Indicator Hardware Setup
3.1 Mounting the 420 Indicator
Location of the indicator is a matter of operator preference and should be installed in a location that allows for free
vision.
The universal mounting bracket which is included (shown in Figure
3-1), enables the indicator to be mounted to the
safety cage using the supplied hardware.
Figure 3-1. CLS Mounting Bracket
The indicator tilt position is adjustable by using a wrench so you can pick the best viewing angle for the operator.
Vibration isolators are also included in the supplied mounting bracket hardware. This cushions the indicator from
vibration. These vibration isolators are shown below.
Rear Side of
Indicator
Vibration Isolators
Figure 3-2. Vibration Isolator Control Location
Note
To permanently lock the indicator mounting bolts, Rice Lake Weighing Systems recommends using
Locktite 262