Rice Lake CLS-420 Cargo Lift Scale Installation Manual - Manual (Page 38)

28 CLS-420 Installation Manual
5.2.3 Calibration Menu
Figure 5-6 illustrates the calibration procedures for the CLS-420 using two load cells. It does not represent the
basic Calibration menu for the 420 indicator
9999999 9999999 9999999 9999999
"/(-&; 87"- $.$&-
"-(065 %*(*/ 4&51/5 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
$.$&-
7&34
$.;&30
.
Figure 5-6. CLS-420 Calibration Menu Using Two Load Cells
9999999 9999999 9999999 9999999
8;&30 87"- 841"/
"-(065 %*(*/ 4&51/5 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
3&;&30
7&34
Figure 5-7.
Table 5-4. SCALES Menu, CALIBR Submenu Parameters
CALIBR Menu
Parameter Choices Description
Level 2, submenu
ANGLEZ — Calibrate the inclinometer pitch and roll angles on the two-channel iQube when the pitch and roll
angles are zero.
This operation tells the two-channel iQube to use the current readings from the MEMS inclinometer
and store these angle measurements as offsets that are applied to the current measurement angle
that are used in calculating the correction factor that is applied to the weight.
CMZERO Setup the two-channel iQube for calibration match (Cal-Match)
This tells the two-channel iQube that the calibration mode is set for Cal-Match, initialize variables
for the calibration then do a Zero Calibration (no load).
WVAL — Display and edit the test weight value
CMCEL1
through
CMCEL2 — This parameter is used to calibrate a particular load cell with a load with CELL1 being the left side
fork as viewed from the drivers position CELL2 being on the right hand side as viewed from the
drivers position.
This tells the two-channel iQube to calibrate a particular load cell.
These steps must be performed in order, CMCEL1 (left fork) first, followed by CMCEL2 (right fork).
Basic 420 Calibration Menu