Rice Lake Digital/Diagnostic - iQube - Manual (Page 16)

Installation 13
2.11.4 Analog Output
The analog output from the iQUBE can be connected to the analog signal inputs of any weight indicator that can
be read 0-30mV (0-20mA) referenced to ground (see Figure 2-12). Analog output from the iQUBE requires that a
digital-to-analog (DAC) card be installed on the iQUBE core module. Both voltage- and current-based DAC
cards are available. See Section 2.14.1 on page 15 for more information about DAC card installation.
NOTE: Analog output wiring must include ground wire (pin 3 on connector J9 on the iQUBE connector board).
Figure 2-12. iQUBE Analog Output Connection to Indicator