Rice Lake Digital/Diagnostic - iQube - Manual (Page 24)

920i Indicator Configuration 21
SYSTEM: The system setup display is divided into three areas:
• System (middle section): Highlight the system being configured, then use the left arrow key to move to
the Available Platform section.
• Available Platforms (left section): Use this section to assign platforms to the system. Use the up and
down keys to highlight the desired platform, then press the Add softkey to assign the platform to the
system.
• Associated Platforms (right section): Lists platforms that have been assigned the system. A system
diagram is displayed in the center of the screen.
Press Done to return to the configuration menu.
2. Press the Download softkey. Use the up and down keys to select Download iQUBE configuration only , then
press enter .
3. Cycle power on the iQUBE to initialize the changed configuration.
4. Press the Save and Exit softkey.
5. Return the 920i to setup mode.
6. Continue configuration of the indicator as described in the 920i Installation Manual.
Other iQUBE - 920i functions and setup information are described in the sections listed below:
• Calibration: see Section 5.0 on page 31
• Contact information: see Section 7.3 on page 40
• Diagnostic setup: see Section 3.4.2 on page 25 and Section 6.0 on page 34
• Alert messaging: see Section 7.0 on page 38
3.3 Configuration and Calibration Summary
Figure 3-1. Configuration and Calibration Summary
Config
Serial Port
Associate
Scale
Config
Scale
Calibr Calib
Step 1 Step 2 Step 3 Step 4 Step 5
Port
Number
Config
Cells
Download
to J-Box
Platform
System
iQUBE
Port
Grads
Format
WZero
Theoretical
Calibration
Cal-
Match
WVal
Final
Calibration
(WSpan)