Rice Lake Digital/Diagnostic - iQube - Manual (Page 52)

Appendix 49
• iRite ™ Programming Reference, PN 67888
Virtui Option Cards
• Virtui Single-Channel A/D Card Installation Instructions, PN 69092
• Virtui Dual-Channel A/D Card Installation Instructions, PN 69090
• Virtui 24-Channel Digital I/O Expansion Card Installation Instructions, PN 69087
• Virtui Serial Expansion Card Installation Instructions, PN 69088
• Virtui Pulse Input Card Installation Instructions, PN 69086
• Virtui Memory Expansion Card Installation Instructions, PN 69085
520/920i Communications Options
• DeviceNet ™ Interface Installation and Programming Manual, PN 69949
• Profibus ® DP Interface Installation and Programming Manual, PN 69948
• Allen-Bradley ® Remote I/O Interface Installation and Programming Manual, PN 69950
• Ethernet Communications Card Installation Instructions, PN 72117
9.3 Flash Update Procedure
Before beginning this procedure, ensure that there are no other processes running on the PC and that the cable
from the programmer is plugged into the PC cable.
1. Insert core board in the iQUBE grey box test fixture or production box.
2. Remove the two jumpers on J3.
3. Connect the blue connector to J3 with red wire to the edge of the board.
4. Turn on the power.
5. Double click AVRSTUDIO4 (LadyBug). This is available on the CD included in the parts kit or at http://
www.atmel.com.
“Welcome to AVR Studio”
6. Select Cancel when iQUBE project is displayed.
7. Click Next .
8. Select the device Atmegal 128
9. Click Finish .
10. Click the AVR button, it looks like an EEPROM.
11. A warning to upgrade may appear.
12. Click Cancel .
13. Go to lock Bits and ensure that all are on Mode 1.
14. Click Program to send Locks to core module.
15. Go to the Fuse tab and ensure that only the following fuses are set.
• WatchDog Timer On
• Preserve EEProm
• Boot Glash = 512
• CKOPT Fuse
• BrownOut = 2.7v
• BrownOut Detection Enabled
• Ext Crystal last box in list
16. Click Program to send fuses to core module.
17. Locate Flash Box.
18. Click Program.
19. Verify that there are no errors.
20. Turn power off.
21. Disconnect the blue connector.