Rice Lake Digital/Diagnostic - iQube - Manual (Page 42)

Alerts 39
7.2 Alert Format
The default 920i alert print format is as follows:
<COMP><NL>
<COAR1><NL>
<COAR2><NL>
<COAR3><NL>
<CONM1><NL>
<COPH1><NL>
<CONM2><NL>
<COPH2><NL>
<CONM3><NL>
<COPH3><NL>
<COML><NL>
<ERR><NL>
Commands used in the 920i alert format are listed
in Table 7-1.
Values for the contact information referenced by the
print formatting commands shown in Table 7-1 can be
s e t u s i n g t h e
9 2 0 i m e n u s ( F E AT U R E m e n u ,
C O N TA C T s u b m e n u ) , s e r i a l c o m m a n d s ( s e e
Section 8.0 on page 42),or the
iRev configuration
utility.
See the 920i Installation Manual, PN 67887, for more
information about print formatting.
Command Content
<COMP> Company name (up to 30 characters)
<COAR1>
<COAR2>
<COAR3> Contact company address, lines 1–3 (up to
30 characters)
<CONM1>
<CONM2>
<CONM3> Contact names (up to 20 characters)
<COPH1>
<COPH2>
<COPH3> Contact phone numbers (up to 20 characters)
<COML> Contact e-mail address (up to 30 characters)
<ERR> Alert error message (system-generated)
<NLnn> New line (nn = number of termination (<CR/
LF> or <CR>) characters). If nn is not
specified, 1 is assumed. Value must be in the
range 1–99.
Table 7-1. Alert Format Commands