Rice Lake Digital/Diagnostic - iQube - Manual (Page 26)

920i Indicator Configuration 23
SERIAL Menu ( iQUBE Submenu)
Parameter Choices Description
CONFIG 8/0/0/0
8/4/0/0
8/4/4/0
8/8/0/0
4/0/0/0
4/4/0/0
4/4/4/0
4/4/4/4
4/8/0/0 Specifies the iQUBE system configuration.
The first value (8 or 4) designates the number of channels on the iQUBE primary board;
the remaining three values represent attached secondary units, if any, and the number of
channels on each secondary board.
NOTE: The iQUBE allocates either 4 or 8 channels per board. Total channels cannot
exceed 16; an 8-channel board cannot be defined as a 4-channel board.
CELLS CELLA1–CELLA8
List of cells for
CONFIG type Depending on the value specified for CONFIG, load cells are listed using default names
with the format CELLxy, where x is the board identifier (A is the primary unit; B, C, and D
are secondary units), and y is a designation (1–4 or 1–8, depending on the number of
channels supported by the board), for the individual load cell.
Subparameters allow load cell ID, capacity, sensitivity, and serial number to be specified.
See descriptions under Level 4 Submenus.
SECTION PAIRED
CIRCULAR Specifies whether the load cells defined for the section are referenced to each other as
pairs or in a circular relationship. Sections with an odd number of cells must specify
CIRCULAR. Full diagnostic capability requires PAIRED section configuration.
See Section 2.3 on page 3 for information about load cell build order.
PLATFM List of cells and
platforms Use the Add softkey to associate load cells with platforms.
SYSTEM List of platforms
and systems Use the Add softkey to associate platforms with an iQUBE system. A system can
consist of 1–4 platforms.
ALGOUT SOURCE
FULLSC Specifies the source system and full scale value for an iQUBE analog output. See
descriptions under Level 4 Submenus.
DIGIO BIT 1 – BIT 8 For iQUBE models with digital I/O, specifies the function of each of the digital I/O bits.
See the 920i Installation Manual, PN 67887, for information about digital I/O functions.
IQDIAG ZEROREF
CELLBAL
LDRIFT
PKtoPK
CELLEMU
MOTBAND See Level 4 Submenus, Figure 3-3 on page 25, and Table 3-2 on page 26.
TESTCOM VALIDAT Select VALIDAT to run a communication validation test for one or more attached
iQUBE s. The validation test returns the serial numbers of all attached iQUBE s.
PORTTYPE RS232
RS485 Specifies the port designation.
Level 4 Submenus
ID load_cell_ID Specifies the load cell ID. Press enter to exit this parameter.
CAPCTY 75000
capacity Enter the rated load cell capacity.
SENS 3.000000
sensitivity (mV/V) Enter the actual or nominal load cell millivolt/volt sensitivity.
SRLNUM serial_number Optional. Enter the load cell serial number.
Table 3-1. Serial Menu Parameters, iQUBE Submenu