B&C Technologies IM Series Industrial Ironer - Manual (Page 60)

Figure 5.10: Roll to Roll Tension Adjustment
5.4.4 Roll to Roll Tension Adjustment
To adjust the roll to roll belt tension proceeds as follows (refer to figure 5.10 on page 50 and the
tension chart, table 5.4 on page 51):
1. Move the main power switch to the off position.
2. Remove side covers on right hand side of ironer.
3. Loosen nuts of tensioner idler located on a turnbuckle.
4. Adjust tension in belts as required.
5. Retighten all fasteners.
6. Replace covers and restart operation.
50