B&C Technologies IM Series Industrial Ironer - Manual (Page 63)

Figure 5.13: Roll Procession Adjustment
1. Move the main power switch to the off position.
2. Remove side covers on the drive side.
3. Loosen nuts at tension idler between the intermediate pulley and the variable pulley.
4. Loosen set screws at the variable pulley outer flange.
5. Turn outer flange as required in 30 degree (rotate 12 o’clock to 1 o’clock for 30 degrees of
rotation) steps. See figure 5.13 on page 53
6. Line up two threaded holes on outer flange of variable pulley with the grooves on the hub,
insert set screws and tighten.
7. Tension the belts by means of the tension idler and tighten all fasteners.
5.6 Roll Padding
5.6.1 Trimming the Roll Padding
The roll padding must be trimmed periodically. More often when a new pad is installed (two
to three times a month), less when the padding is aged and ”settled” (once every two months).
53